ProStart CT-5072 Guide de l'utilisateur télécharger pdf (Page 9)

User guide P.9

ExtendedRunTime

This procedure can only be carried out once per remote start.

While the vehicle is running remotely, pressing and releasing the button for 1 second will reset

the run time counter to zero and restart the run time cycle from the beginning. The siren will sound

and the parking lights will flash slowly 3 times then remain lit.

To stop the vehicle at any moment, simply press and release the button.

Example: If your Module is programmed for a runtime of 3 minutes and your vehicle has been

running for 2 minutes already, pressing the button will reset the counter to zero and the Engine

will run for another cycle (in this case, 3 minutes).

IntrusionCodesviaLEDlight

The system monitors the following:

• Any vibrations sensed by the system such as someone breaking the window,

windshield, etc.

• Doors

• Ignition

• Hood

Note: If an intrusion has occurred the siren will sound for a maximum of 1minute.

When an intrusion has occurred, pressing unlock will make the siren chirps four times. The

antenna’s LED will provide an intrusion code corresponding to the type of the intrusion that

occurred. The LED intrusion codes are flashed in continuous loops.

2x = Doors intrusion 5x = Panic

3x = Shock Sense 6x = Ignition

4x = Hood

CarFinder

When enabled, the Car Finder option will help you locate your vehicle by sending a pulsating signal

through the siren. To hear the signal, press the and buttons simultaneously. This will

produce a pulsating signal for the time you keep the buttons pressed.

TemporaryChirpDelete

To temporarily disable the chirp confirmations of the siren upon arming and disarming (e.g. in a

quiet neighbourhood):

• Press the button. The parking lights will flash once.

• Immediately press the or

button to arm or disarm system without any chirp.



1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

ProStart CT-5072 Guide de l'utilisateur Page 9