ProStart CT-3371 Guide d'installation télécharger pdf (Page 20)

P.20 Installation guide

VirtualTachSystem

Virtual Tach System combines the latest microcontroller technology and a complex algorithm that

took years to develop. VTS is able to effectively monitor the engine starting sequence and release

the starter at the right time without physically connecting the tach wire to the remote starter. The

VTS constantly monitors the data and readjusts itself automatically in order to maximize its

capability to start the engine properly in any weather or deteriorating battery condition

Note: Virtual Tach System is only available in automatic transmission.

OptionalTimeDelayAdjustmentinVirtualTachSystem

Follow these steps to program crank time adjustment, if needed:

1. Enter programming mode (page-17) ⎯ the parking lights will stay on for up to 20

seconds.

2. Before the lights go out, press and hold the brake pedal and press the and

buttons simultaneously ⎯ the parking lights will flash 4 times. Do not release the

brake pedal.

3. Press the

button if you wish to increase the time delay or the button if you want

to decrease it. The time delay will be increased or decreased by 50ms. and the parking

lights will flash once every time the or button is pressed.

4. Press the

button to save the settings you have entered. The parking lights will flash

5 times.

5. Release the brake pedal – the time delay programming is now complete.

TachLearning

Tachjumpersettings

Some new vehicles have a higher TACH

voltage threshold, which would fall out of

the normal TACH trigger circuit of the

remote car starter. Changing the jumper

to TACH Threshold HIGH will allow the

module to properly detect the TACH

signal.



MultispeedTachProgrammingProcedure



The system is designed to read a wide range of Tach signals produced by newer Ignition

systems. Note that you should go through the Tach programming procedure every time a new

Unit is installed.

1. Enter programming mode (page-17) ⎯ the parking lights will stay on for up to 20

seconds.

2. Before the lights go out, press and hold the brake pedal and press the

and

buttons simultaneously ⎯ the parking lights will flash 4 times.

3. Release the brake pedal.

4. Start up the engine and allow the vehicle to reach regular engine idle speed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

ProStart CT-3371 Guide d'installation Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Les démarreurs à distance ProStart CT-3371