ProStart CT-3371 Guide de l'utilisateur Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
P.6 User Guide
- The parking lights will flash once.
- The LED on the antenna will flash slowly.
To disarm the Starter Kill, press the button on the transmitter.
- The parking lights will flash twice.
- The LED on the antenna will remain OFF.
RemoteStarterFeatures
RemoteDoorLocks
If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To lock your doors and arm the starter kill (if installed):
1. Press and hold the button for approx. 1 sec.
2. The parking lights will flash once to confirm that the doors have been locked
To unlock your doors and disarm the starter kill (if installed):
1. Press and hold the button for approx. 1 sec.
2. The parking lights will flash twice to confirm that the doors have been unlocked.
RemoteTrunkRelease
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the button for 3 seconds on the remote transmitter.
IdleMode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:
1. With the engine running, make sure to release the brake pedal and press the ,
or button on the transmitter until the parking lights come ON.
2. Remove the ignition key from the ignition switch.
The engine will continue running.
3. Exit the vehicle and close all doors, hood and trunk.
4. Press the , button to leave the doors locked and the starter kill armed.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode (page-4); at the last step, the button is pressed instead of the
other buttons.
Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of
the engine run time.
Note2: If the pre-programmed run-time expires or if the user shuts down the engine by remote
control, the vehicle will enter Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Vue de la page 5
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire